Suspended Timber Floor Construction

If there s wall board covered ceiling suspended from the underside of that floor the dead load increases to about 10 pounds per square foot.

Suspended timber floor construction.

The materials can be more expensive than other flooring options but there is very little needed in the way of ground preparation which makes the overall cost lower on the whole particularly for the labour involved. Suspended timber floors which are typically found in older houses are normally made from timber floorboards which are then attached to joists just above the foundations of a house. Different types of ground floor suspended flooring. 6 4 12 joists connected to steel.

That leaves an opening to improve moisture management and airtightness by fitting a tyvek membrane and carefully sealing the gaps and joints. They can normally span greater distances than timber joists. 6 4 10 construction of timber floors. 6 4 11 joists supported by intermediate walls.

6 4 13 joists into hangers. Suspended timber floors need to have spaces underneath ventilated via air bricks through the outer walls and gaps in any internal walls so that the air can move across the building underneath the floors to prevent the build up of moisture in the timber which could lead to fungal attack. A suspended floor is a ground floor with a void underneath the structure. This construction is similar to the timber floor above but uses either pre cast concrete planks or small pre cast concrete beams with concrete blocks laid between the beams.

The floor can be formed in various ways using timber joists precast concrete panels block and beam system or cast in situ with reinforced concrete. All you need to know. The dead load on a floor is determined by the materials used in the floor s construction. Suspended timber ground floors consist of the finished timber floorboards being attached to floor joists which are suspended above the subfloor of the foundation.

Previously floor timbers had been prone to damp and rot thanks to their direct contact with the moist ground. Many suspended timber floor constructions have discontinuous insulation between the joists. 5 2 suspended ground floors. This chapter gives guidance on meeting the technical requirements for suspended ground floors including those constructed from.

This creates a small gap and allows ventilation and air movement to prevent damp forming in the timber joists. Moisture management for suspended timber floor construction. A typical wood frame floor covered with carpet or vinyl flooring has a dead load of about 8 pounds per square foot. Ventilation is required in the same way as a suspended timber floor.